Configuring The Notification Target User; Configuring Linkup/Linkdown Notifications For Interfaces - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 27 Configuring SNMP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
fcs request-reject
fcs discovery-complete
fdmi
fspf
license
port-security
rscn els
rscn ils
snmp authentication
vrrp
zone unsupported member
zone request-reject
zone merge-failure
zone merge-success
zone default-zone-behavior-change

Configuring the Notification Target User

You must configure a notification target user on the switch for sending SNMPv3 inform notifications to
the SNMP manager.
To configure the notification target user, use the following command:
Command
Step 1
switch# config t
Step 2
switch(config)# snmp-server user testusr
auth md5 xyub20gh priv xyub20gh engineID
00:00:00:63:00:01:00:a1:ac:15:10:03
switch(config)# no snmp-server user testusr
auth md5 xyub20gh priv xyub20gh engineID
00:00:00:63:00:01:00:a1:ac:15:10:03
The credentials of the notification target user are used for encrypting the SNMPv3 inform notification
messages to the configured SNMP manager (as in the snmp-server host command).
For authenticating and decrypting the received INFORM PDU, the SNMP manager should have the same
Note
user credentials in its local configuration data store of users.

Configuring LinkUp/LinkDown Notifications for Interfaces

As of Cisco MDS SAN-OS Release 2.1(2), you can configure which linkUp/linkDown notifications to
enable on the interfaces. You can enable the following types of linkUp/linkDown notifications:
•
•
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Cisco—Only traps (cieLinkUp, cieLinkDown) defined in CISCO-IF-EXTENSION-MIB.my are
sent for an interface, if ifLinkUpDownTrapEnable (defined in IF-MIB) is enabled for that interface.
IETF—Only traps (linkUp, linkDown) defined in IF-MIB are sent for an interface, if
ifLinkUpDownTrapEnable (defined in IF-MIB) is enabled for that interface. Only the varbinds
defined in the trap definition are sent with the traps.
Configuring SNMP Notifications (Traps and Informs)
No
No
No
No
Yes
No
No
No
No
Yes
No
No
No
No
No
Purpose
Enters configuration mode.
Configures the notification target user with the
specified credentials for the SNMP manager with
the specified engineID
Removes the notification target user.
Cisco MDS 9000 Family Configuration Guide
27-11