Displaying Interface Information - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 11 Configuring Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To configure a CIM server using the HTTPS protocol, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# cimserver certificate
bootflash:simserver.pem
switch(config)# cimserver clearcertificate
Certificate1
Step 3
switch(config)# cimserver enableHttps
switch(config)# no cimserver enableHttps
Step 4
switch(config)# cimserver enable
switch(config)# no cimserver enable
To configure a CIM server using the HTTP protocol, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# cimserver enable
switch(config)# no cimserver enable
switch(config)# no cimserver enableHttp
switch(config)# cimserver enableHttp

Displaying Interface Information

The show interface command is invoked from the EXEC mode and displays the interface
configurations. Without any arguments, this command displays the information for all the configured
interfaces in the switch. See Examples
Example 11-1 Displays All Interfaces
switch# show interface
fc1/1 is up
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Hardware is Fibre Channel, SFP is short wave laser
Port WWN is 20:0b:00:05:30:00:8d:de
Admin port mode is F
Port mode is F, FCID is 0x610000
Port vsan is 2
Speed is 2 Gbps
Transmit B2B Credit is 3
Receive B2B Credit is 16
Receive data field Size is 2112
Beacon is turned off
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
134 frames input, 8468 bytes
0 discards, 0 errors
0 CRC, 0 unknown class
Purpose
Enters configuration mode.
Installs a Secure Socket Layer (SSL) certificate
specified in the file named with a .pem extension.
Optional. Clears the specified SSL certificate
(Certificate1).
Enables HTTPS (secure protocol).
Optional. Disables HTTPS (default).
Enables the CIM server.
Optional. Disables the CIM server (default).
Purpose
Enters configuration mode.
Enables the CIM server using the default HTTP
(non-secure) protocol.
Optional. Disables the CIM server (default).
Optional. Disables HTTP.
Optional. Enables HTTP and reverts to the
switch default.
11-1 to 11-15.
Cisco MDS 9000 Family Configuration Guide
Displaying Interface Information
11-23