Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual page 947

Chapter 43 Monitoring Network Traffic Using SPAN
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Enabling FC Tunnels
To enable the FC tunnel feature, follow these steps:
Command
Step 1
switchS# config t
Step 2
switchS(config)# fc-tunnel enable
Be sure to enable this feature in each switch in the end-to-end path in the tunnel.
Note
Configuring the SD Port
The SD port in the destination switch enables the FC analyzer to receive the RSPAN traffic from the
Fibre Channel tunnel.
is also configured.
Figure 43-12
source switch S
IP address of VSAN 5
interface = 10.10.10.1
SD ports cannot be configured using Advanced Services Modules (ASMs) or Storage Services Modules
Note
(SSMs).
To configure an SD port for the scenario in
Command
Step 1
switchD# config t
Step 2
switchD(config)# interface fc2/1
Step 3
switchD(config-if)# switchport mode SD
Step 4
switchD(config-if)# switchport speed 2000
Step 5
switchD(config-if)# no shutdown
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Figure 43-12
RSPAN Tunnel Configuration
Cisco MDS
ST port
ST
RSPAN tunnel
Purpose
Enters configuration mode.
Initiates the FC tunnel (100) in the source switch
(switch S). The tunnel IDs range from 1 to 255.
depicts an RSPAN tunnel configuration, now that tunnel destination
Cisco MDS
Fibre Channel
fabric
SD port
IP address of VSAN 5
interface = 10.10.10.2
Figure 43-12, follow these steps:
Purpose
Enters configuration mode.
Configures the specified interface.
Configures the SD port mode for interface fc2/1.
Configures the SD port speed to 2000 Mbps.
Enables traffic flow through this interface.
Cisco MDS 9000 Family Configuration Guide
Remote SPAN
Cisco MDS
destination switch D
SD
fc2/1
FC Analyzer
43-23