Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual page 857

Chapter 36 Configuring IP Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To configure the management interface displayed in
Note
on the Ethernet network.
The following procedure configures an overlay VSAN in one switch. This procedure must be repeated
for each switch in the fabric.
To configure an overlay VSAN in one switch (using the example in
Command
Step 1
switch# config t
Step 2
switch(config)# vsan database
switch-config-vsan-db#
Step 3
switch--config-vsan-db# vsan 10 name MGMT_VSAN
Step 4
switch--config-vsan-db# exit
switch(config)#
Step 5
switch(config)# interface vsan10
switch(config-if)#
Step 6
switch(config-if)# ip address 10.10.10.0
netmask 255.255.255.0
Step 7
switch(config-if)# no shut
Step 8
switch--config-if# end
switch#
Step 9
switch# exit
To configure the NMS station displayed in
Command
Step 1
nms# route ADD 10.10.10.0 MASK 255.255.255.0
172.22.93.74
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Figure 36-4, set the default gateway to an IP address
Figure
Purpose
Enters configuration mode.
Configures the VSAN database.
Defines the VSAN in the VSAN database on
all of the switches in the Fibre Channel fabric.
Exits the VSAN database mode.
Creates a VSAN interface (VSAN 10).
Assigns an IP address and netmask for this
switch.
Enables the configured interface.
Exits to EXEC mode.
Exits the switch and returns to the NMS. In
this example the NMS is assumed to be on the
same subnet of the Ethernet management
interface of the edge that provides access to
the Fibre Channel fabric.
Figure 36-4, follow this step:
Purpose
Defines a static route on the NMS pointing to
the management interface of the edge switch
that provides access to the Fibre Channel
fabric.
Cisco MDS 9000 Family Configuration Guide
Overlay VSAN Configuration
36-4), follow these steps:
36-13