Displaying Cdp Information - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Configuring CDP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Displaying CDP Information

Use the show cdp command to display CDP entries. See Examples
Example 4-1
switch# show cdp all
GigabitEthernet4/1 is up
GigabitEthernet4/8 is down
mgmt0 is up
Example 4-2
switch# show cdp entry all
----------------------------------------
Device ID:069038747(Kiowa3)
Entry address(es):
Platform: WS-C5500, Capabilities: Trans-Bridge Switch
Interface: mgmt0, Port ID (outgoing port): 5/22
Holdtime: 136 sec
Version:
WS-C5500 Software, Version McpSW: 2.4(3) NmpSW: 2.4(3)
Copyright (c) 1995-1997 by Cisco Systems
Advertisement Version: 1
Example 4-3
switch# show cdp entry name 0
----------------------------------------
Device ID:0
Entry address(es):
Platform: DS-X9530-SF1-K9, Capabilities: Host
Interface: GigabitEthernet4/1, Port ID (outgoing port): GigabitEthernet4/1
Holdtime: 144 sec
Version:
1.1(0.144)
Advertisement Version: 2
Duplex: full
Cisco MDS 9000 Family Configuration Guide
4-34
Displays All CDP Capable Interfaces and Parameters
CDP enabled on interface
Sending CDP packets every 60 seconds
Holdtime is 180 seconds
CDP enabled on interface
Sending CDP packets every 60 seconds
Holdtime is 180 seconds
CDP enabled on interface
Sending CDP packets every 100 seconds
Holdtime is 200 seconds
Displays All CDP Neighbor Entries
IP Address: 172.22.92.5
Displays the Specified CDP Neighbor
IP Address: 0.0.0.0
Chapter 4 Initial Configuration
4-1 to 4-11.
OL-6973-03, Cisco MDS SAN-OS Release 2.x