Quality Of Service; Configuring E Ports - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Configuring E Ports

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Command
Step 2
switch(config-if)# bport-keepalive
switch(config-if)# no bport-keepalive

Quality of Service

The Quality of Service (QoS) parameter specifies the differentiated services code point (DSCP) value to
mark all IP packets (type of service—TOS field in the IP header).
•
•
If the FCIP link has only one TCP connection, that data DSCP value is applied to all packets in that
connection.
To set the QoS values, follow these steps:
Command
Step 1
switch(config-if)# qos control 24 data 26
switch(config-if)# no qos control 24 data 26
Configuring E Ports
All configuration commands that apply to E ports, also apply to FCIP interfaces. The following features
are also available for FCIP interfaces:
•
•
•
•
•
•
Cisco MDS 9000 Family Configuration Guide
33-18
The control DSCP value applies to all FCIP frames in the control TCP connection.
The data DSCP value applies to all FCIP frames in the data connection.
An FCIP interface can be a member of any VSAN (see
VSANs").
Trunk mode and trunk allowed VSANs (see
PortChannels (see Chapter 13, "Configuring
Multiple FCIP links can be bundled into a Fibre Channel PortChannel.
–
FCIP links and Fibre Channel links cannot be combined in one PortChannel.
–
FSPF (see Chapter 21, "Configuring Fibre Channel Routing Services and
Fibre Channel domains (fcdomains) (see
Importing and exporting the zone database from the adjacent switch (see
and Managing Zones").
Purpose
Enables the reception of keepalive responses sent by a
remote peer.
Disables the reception of keepalive responses sent by a
remote peer (default).
Purpose
Configures the control TCP connection and data
connection to mark all packets on that DSCP
value. The control and data value ranges from 0
to 63.
Reverts the switch to its factory default (marks
all packets with DCSP value 0).
Chapter 16, "Configuring and Managing
Chapter 12, "Configuring
PortChannels"):
Chapter 14, "Configuring Domain
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Chapter 33 Configuring FCIP
Trunking").
Protocols").
Parameters.").
Chapter 19, "Configuring