Using The Install Ssi Command - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 10 Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Issue the show module command to verify the status of the SSM.
Step 8
switch# show module
Mod
---
4
5
6
Mod
---
4
5
6
Mod
-------- -----------------------------
4
Mod
---
4
5
6
* this terminal session

Using the install ssi Command

As of Cisco MDS SAN-OS Release 2.1(2), you can use the install ssi command to update the boot image
on an SSM. If the SSM is performing Fibre Channel switching and no Intelligent Storage Services are
provisioned on the module, this operation does not disrupt traffic through the module. If the SSM is
configured for Intelligent Storage Services, a warning is displayed at the command prompt indicating
that the operation will disrupt traffic and asking if you wish to continue.
The SSM must be running EPLD version 2.1(2) to use the install ssi command. You must install the SSM
Note
on a Cisco MDS 9500 Series switch to update the EPLD. See the
page
To upgrade or downgrade the SSM boot image for Intelligent Storage Services, follow these steps:
Log into the switch through the console port, an SSH session, or a Telnet session.
Step 1
Verify that the SSM is physically installed in the switch. If the module is not physically installed, insert
Step 2
it into the desired slot. Issue a show module command to verify the status of the module.
switch# show module
Mod
---
4
5
6
...
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Ports Module-Type
----- -------------------------------- ------------------ ------------
32 Storage Services Module
0 Supervisor/Fabric-1
0 Supervisor/Fabric-1
Sw Hw World-Wide-Name(s) (WWN)
----------- ------ --------------------------------------------------
2.1(2) 0.30 20:c1:00:05:30:00:06:de to 20:e0:00:05:30:00:06:de
2.1(2) 4.0 --
2.1(2) 4.0 --
Application Image Description
SSI linecard image
MAC-Address(es)
--------------------------------------
00-05-30-00-9e-b2 to 00-05-30-00-9e-b6
00-0e-38-c6-2c-6c to 00-0e-38-c6-2c-70
00-0f-34-94-4d-34 to 00-0f-34-94-4d-38
10-15.
Ports Module-Type
----- -------------------------------- ------------------ ------------
32 Storage Services Module
0 Supervisor/Fabric-1
0 Supervisor/Fabric-1
Installing the SSI Boot Image on the SSM
Model Status
DS-X9032-SSM ok
DS-X9530-SF1-K9 active *
DS-X9530-SF1-K9 ha-standby
Application Image Version
-------------------------
2.1(1a)
Serial-Num
----------
JAB06480590
JAB082504MQ
JAB083407D3
"EPLD Configuration" section on
Model Status
DS-X9032-SSM ok
DS-X9530-SF1-K9 active *
DS-X9530-SF1-K9 ha-standby
Cisco MDS 9000 Family Configuration Guide
10-27