Schedule Definition; Periodic Schedule Definition - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 15 Scheduling Maintenance Jobs
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Schedule Definition

After defining jobs, you can create schedules and assign jobs to the schedule. Subsequently, you can
configure the time of execution. The execution can be one-time or periodic depending on your
requirements. If the time for the schedule is not configured, then it will never be executed.

Periodic Schedule Definition

When you specify a periodic job execution, that job is executed periodically at the specified (daily,
weekly, monthly, or delta) intervals.
To specify a periodic job for the command scheduler, follow these steps:
Command
Step 1
switch# conf t
switch(config)#
Step 2
switch(config)# scheduler schedule name
weekendbackupqos
switch(config-schedule)#
switch(config)# no scheduler schedule
name weekendbackup
Step 3
switch(config-schedule)# job name
offpeakZoning
switch(config-schedule)# job name
offpeakQOS
switch(config-schedule)# no job name
addMem99
The following examples are only provided for reference.
Note
Step 4
switch(config-schedule)# time daily
23:00
switch(config-schedule)# time weekly
Sun:23:00
switch(config-schedule)# time monthly
28:23:00
switch(config-schedule)# time start now
repeat 48:00
switch(config-schedule)# time start
14:00 repeat 14:00:00
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Purpose
Enters the configuration mode.
Defines a job schedule (weekendbackup) and enters
the submode for that schedule.
Deletes the defined schedule.
Assign two jobs offpeakZoning and offpeakQOS for
this schedule.
Deletes the job assigned for this schedule.
Executes the specified jobs at 11 p.m. every day.
Specifies a weekly execution every Sunday at11 p.m.
Specifies a monthly execution at 11 p.m on the 28th of
each month. If you specify the date as either 29, 30, or
31, the command is automatically executed on the last
day of each month.
Specifies a job to be executed every 48 hours
beginning 2 minutes from now —if today is
September 24th 2004 and the time is now 2:00 p.m.,
the command begins executing at 2 minutes past 2:00
p.m. on September 24th 2004 and continues to execute
every 48 hours after that.
If today is September 24th, 2004 (Friday), this
command specifies the job to be executed every
alternate Friday at 2 p.m. (every 14 days).
Cisco MDS 9000 Family Configuration Guide
Scheduler Configuration
15-5