Table of Contents
Advertisement
Chapter 35
Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Step 11
Create a zone with host 2 and two Fibre Channel targets.
Note
switch(config)# zone name iscsi-zone-2 vsan 2
Activate the zone set in VSAN 2
Step 12
switch(config)# zoneset activate name iscsi-zoneset-v2 vsan 2
Zoneset activation initiated. check zone status
switch# show zoneset active vsan 2
zoneset name iscsi-zoneset-v2 vsan 2
zone name iscsi-zone-2 vsan 2
* fcid 0x750001 [pwwn 21:00:00:20:37:6f:fe:54]
* fcid 0x750101 [pwwn 21:00:00:20:37:a6:a6:5d]
Start the iSCSI clients on both hosts and verify that sessions come up.
Step 13
Step 14
Display the iSCSI sessions to verify the Fibre Channel target and the configured WWNs.
switch# show iscsi session
Initiator iqn.1987-05.com.cisco:01.e41695d16b1a
Session #1
Session #2
iqn.1987-05.com.cisco:05.172.22.92.166.07-01.21000020376ffd97
Display the iSCSI initiator to verify the configured nWWN and pWWN.
Step 15
switch# show iscsi initiator
iSCSI Node name is iqn.1987-05.com.cisco:01.e41695d16b1a
Virtual Port WWN is 20:02:00:0b:fd:44:68:c2 (configured)
OL-6973-03, Cisco MDS SAN-OS Release 2.x
If the host is in VSAN 2, the Fibre Channel targets and zone must also be in VSAN 2.
pwwn 20:06:00:0b:fd:44:68:c2
Initiator ip addr (s): 10.11.1.10
Discovery session, ISID 00023d000001, Status active
Target
VSAN 1, ISID 00023d000001, Status active, no reservation
Initiator ip addr (s): 10.11.1.10
iSCSI alias name: oasis10.cisco.com
Node WWN is 20:03:00:0b:fd:44:68:c2 (configured)
Member of vsans: 1
Number of Virtual n_ports: 1
Interface iSCSI 7/1, Portal group tag: 0x300
VSAN ID 1, FCID 0x680102
iSCSI Authentication Setup Guidelines and Scenarios
<-----------------Host is not online
<----------
<----
Cisco MDS 9000 Family Configuration Guide
<----
To Fibre Channel
target
The configured nWWN
The configured pWWN
35-55
Advertisement
Table of Contents
