Table of Contents
Advertisement
Chapter 40
Configuring SANTap
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Command
Step 2
switch(config)# ssm enable feature santap
module 4
switch(config)# no ssm enable feature santap
module 4
switch(config)# no ssm enable feature santap
force module 4
Step 3
switch(config)# ssm enable feature santap
interface fc 4/1 - 4
switch(config)# no ssm enable feature santap
interface fc 4/1 - 4
switch(config)# no ssm enable feature santap
force interface fc 4/1 - 4
Step 4
switch(config)# santap module 4 appl-vsan 10
switch(config)# no santap module 4 appl-vsan 10
Note
You cannot simultaneously configure the intelligent services SANTap and NASB on a single SSM.
Displaying SANTap Information
Use the show santap module command to display information about SANTap (see
Example
Example 40-1 Displays SANTap Control Virtual Terminal Information
switch# show santap module 2 cvt
CVT Information :
OL-6973-03, Cisco MDS SAN-OS Release 2.x
40-8).
cvt pwwn
= 25:3c:00:05:30:00:22:25
cvt nwwn
= 25:3d:00:05:30:00:22:25
cvt id
= 1
cvt xmap_id
= 2
cvt vsan
= 10
Displaying SANTap Information
Purpose
Enables the SANTap application on the entire
SSM.
Disables the SANTap application on the entire
SSM in slot 4.
Forces the switch to disable the SANTap
application on the entire SSM in
slot 4.
Enables the SANTap application on ports 1
through 4 on the SSM.
Interfaces must be specified in
Note
multiples of four beginning at ports 1,
5, 9, 13, 17, 21, 25, and 29.
Disables the SANTap application on ports 1
through 4 on the SSM in slot 4.
Forces the switch to disable the SANTap
application on ports1 through 4 on the SSM in
slot 4.
Enables SANTap on the SSM in slot 4 and on
VSAN 10.
Disables SANTap.
Cisco MDS 9000 Family Configuration Guide
Example 40-1
to
40-5
Advertisement
Table of Contents
