Supervisor - Cisco Firepower 9300 Hardware Installation Manual

Hide thumbs Also See for Firepower 9300:

Table of Contents

Overview

For More Information

Supervisor

The Firepower 9300 contains a supervisor management I/O card called the Firepower 9300 Supervisor, which

is located on the front panel. The Supervisor provides chassis management and eight 1- or 10-Gb SFP+

interfaces, and it directs traffic to/from the Firepower 9300 security modules.

Note

Unless you are running FXOS software, if you change the SFP transceiver for the management interface, you

must reboot the Firepower 9300. FXOS then detects the new SFP module.

The Supervisor has the following ports:

• RJ-45 console port

• One Gigabit Ethernet SFP management port

• USB 3.0 Type A port

• Eight ports that support 1- or 10-Gigabit Ethernet SFPs (fiber and copper) (Ethernet 1/1 through 1/8)

Figure 7: Firepower 9300 Supervisor Front Panel

Fan module FAN-2

Fan module FAN-4

• See

Chassis Components, on page 4

• See

Fan Modules, on page 28

• See

Power Supply Modules, on page 26

RJ-45 console port

Fan module FAN-3

Grounding lug

for detailed information about the power switch.

for detailed information about the fan modules.

for detailed information about the power supply modules.

Gigabit Ethernet management port

Cisco Firepower 9300 Hardware Installation Guide

Table of Contents