Table of Contents
Advertisement
EPLD Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Note
Use the install module number epld url command on the active supervisor module to upgrade EPLD
Step 6
images for a module.
switch# install module 2 epld bootflash:m9000-epld-2.1.2.img
EPLD
-------------------------------------------------------
XBUS IO
UD Flow Control
PCI ASIC I/F
PCI Bridge
WARNING: Upgrade process could take upto 15 minutes.
Module 2 will be powered down now!!
Do you want to continue (y/n) ? y
<------------------------------------------------------------progress twirl
\
Module 2 EPLD upgrade is successful
If you forcefully upgrade a module that is not online, all EPLDs are forcefully upgraded. If the module
is not present in the switch, an error is returned. If the module is present, the command process continues.
To upgrade a module that is not online but is present in the chassis, use the same command. The switch
software prompts you to continue after reporting the module state. When you confirm your intention to
continue, the upgrade continues.
switch# install module 2 epld bootflash:m9000-epld-2.1.2.img
<------------------------------------------------------------progress twirl
\
Module 2 EPLD upgrade is successful
Note
The same procedure used to upgrade the EPLD images on a module can be used to downgrade the EPLD
Note
images.
Cisco MDS 9000 Family Configuration Guide
10-18
The system will automatically synchronize the ELPD image to the standby supervisor if
automatic copying is enabled.
switch# config t
switch(config)# boot auto-copy
When you upgrade the EPLD module on Cisco MDS 9100 Series switches, you receive the
following message:
Data traffic on the switch will stop now!!
Do you want to continue (y/n) ?
Curr Ver
New Ver
0x07
0x07
0x05
0x05
0x05
0x05
0x05
0x07
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Chapter 10
Managing Modules
Advertisement
Table of Contents
