Default Settings - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure 11-4
Private
target (T1)
Follow these guidelines when configuring private loops:
•
•
•
•
•
•
Default Settings
Table 11-7
Table 11-7
Parameters
Interface mode
Interface speed
Management port
Administrative state
Cisco MDS 9000 Family Configuration Guide
11-34
TL Port Translation Support Examples
Private
initiator (I4)
NL port
NL port TL port
Private
loop
Public
target (3)
A maximum of 64 fabric devices can be proxied to a private loop.
Fabric devices must be in the same zone as private loop devices to be proxied to the private loop.
Each private device on a TL port may be included in a different zone.
All devices on the loop are treated as private loops. You cannot mix private and public devices on
the loop if the configured port mode is TL.
The only FC4-type supported by TL ports is SCSI (FCP).
Communication between a private initiator to a private target on the same private loop does not
invoke TL port services.
lists the default settings for interface parameters.
Default Interface Parameters
Private
initiator (I1)
Public
target (T2)
NL port
Private
loop
N port
F port
TL port
FL port
Public
NL port
loop
NL port
Public
initiator (I3)
Default
Auto
Auto
100 Mbps in full duplex mode
Shutdown (unless changed during initial setup)
Chapter 11 Configuring Interfaces
Public
initiator (I2)
N port
F port
OL-6973-03, Cisco MDS SAN-OS Release 2.x