Table of Contents
Advertisement
Basic FCIP Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To assign FCIP profile in switch 2, follow these steps:
Command
Step 1
switch2# config terminal
switch2(config)#
Step 2
switch2(config)# fcip profile 20
switch2(config-profile)#
Step 3
switch2(config-profile)# ip address 10.1.1.1
Creating FCIP Links
When two FCIP link endpoints are created, an FCIP link is established between the two IPS modules or
MPS-14/2 modules. To create an FCIP link, assign a profile to the FCIP interface and configure the peer
information. The peer IP switch information initiates (creates) an FCIP link to that peer switch (see
Figure
Figure 33-5 Assigning Profiles to Each Gigabit Ethernet Interface
Connecting switch (peer) = 10.1.1.1
IP address of Gigabit Ethernet
interface 3/1 = 10.100.1.25
To create an FCIP link endpoints in switch 1, follow these steps:
Command
Step 1
switch1# config terminal
switch(config)#
Step 2
switch1(config)# interface fcip 51
switch1(config-if)#
Step 3
switch1(config-if)# use-profile 10
Step 4
switch1(config-if)# peer-info ipaddr 10.1.1.1
Step 5
switch1(config-if)# no shutdown
Cisco MDS 9000 Family Configuration Guide
33-6
33-5).
Endpoint
Interface FCIP = 51
Profile = 10
Switch 1
FCIP link
Switch 1
IP router
Purpose
Enters configuration mode.
Creates a profile for the FCIP connection.
Associates the profile (20) with the local IP
address of the Gigabit Ethernet interface.
Endpoint
Interface FCIP = 52
Profile = 20
Connecting switch (peer) = 10.100.1.25
Virtual (E) ISL
IP router
IP
network
IP address of Gigabit Ethernet
interface 3/1 = 10.1.1.1
Purpose
Enters configuration mode.
Creates an FCIP interface (51).
Assigns the profile (10) to the FCIP interface.
Assigns the peer IP address information
(10.1.1.1 for switch 2) to the FCIP interface.
Enables the interface.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Chapter 33
Configuring FCIP
Switch 2
Switch 2
Advertisement
Table of Contents
