Table of Contents
Advertisement
Identifying Module LEDs
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
The LEDs on the supervisor module indicate the status of the supervisor module, power supplies, and
the fan module.
Table 10-8
LED
Status
System
Active
Pwr Mgmt
MGMT 10/100
Ethernet Link
LED
MGMT 10/100
Ethernet
Activity LED
CompactFlash
1. The System and Pwr Mgmt LEDs on a redundant supervisor module are synchronized to the active supervisor module.
Cisco MDS 9000 Family Configuration Guide
10-14
Table 10-8
provides more information about these LEDs.
LEDs for the Cisco MDS 9500 Series Supervisor Modules
Status
Description
Green
All diagnostics pass. The module is operational (normal initialization
sequence).
Orange The module is booting or running diagnostics (normal initialization
sequence).
or
An over temperature condition has occurred (a minor threshold has been
exceeded during environmental monitoring).
Red
The diagnostic test failed. The module is not operational because a fault
occurred during the initialization sequence.
or
An over temperature condition occurred (a major threshold was exceeded
during environmental monitoring).
1
Green
All chassis environmental monitors are reporting OK.
Orange The power supply has failed or the power supply fan has failed.
or
Incompatible power supplies are installed.
or
The redundant clock has failed.
Red
The temperature of the supervisor module major threshold has been
exceeded.
Green
The supervisor module is operational and active.
Orange The supervisor module is in standby mode.
1
Green
Sufficient power is available for all modules.
Orange Sufficient power is not available for all modules.
Green
Link is up.
Off
No link.
Green
Traffic is flowing through port.
Off
No link or no traffic.
Green
The external CompactFlash card is being accessed.
Off
No activity.
Chapter 10
Managing Modules
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Advertisement
Table of Contents
