Mapping Of Cli Operations To Snmp - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 26 Configuring Users and Common Roles
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Configuring Common Roles
CLI and SNMP in all switches in the Cisco MDS 9000 Family use common roles. You can use SNMP
to modify a role that was created using CLI and vice versa (see
Figure 26-1
Switch 1
Each role in SNMP is the same as a role created or modified through the CLI (see the
Authorization" section on page
Each role can be restricted to one or more VSAN as required.
You can create new roles or modify existing roles using SNMP or the CLI.
•
•

Mapping of CLI operations to SNMP

SNMP has only three possible operations: GET, SET and NOTIFY. The CLI has five possible operations:
DEBUG, SHOW, CONFIG, CLEAR and EXEC.
NOTIFY does not have any restrictions like the syslog messages in the CLI.
Note
Table 26-1
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Common Roles
Common Roles
Role: network admin
Description: Predefined network admin
access to all the switch commands
Role: network-operator
Description: Predefined network operation
access to show commands and selected E
Role: sangroup
Description: SAN management group
Rule Type Command-type
1. permit config
2. deny
config
3. permit
debug
4. permit
exec
SNMP—Use the CISCO-COMMON-ROLES-MIB to configure or modify roles. Refer to the Cisco
MDS 9000 Family MIB Quick Reference.
CLI—Use the role name command.
explains how the CLI operations are mapped to the SNMP operations.
Features
*
fspf
zone
fcping
26-1).
Cisco MDS 9000 Family Configuration Guide
Configuring Common Roles
Figure 26-1).
CLI
SNMP
"Role-Based
26-9