Table of Contents
Advertisement
Default SPAN and RSPAN Settings
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Example 43-8 Displays FC Tunnel Egress Mapping Information
switch# show fc-tunnel tunnel-id-map
tunnel id egress interface
Multiple tunnel IDs can terminate at the same interface.
Note
Example 43-9 Displays FC Tunnel Explicit Mapping Information
switch# show fc-tunnel explicit-path
Explicit path name: Alternate1
Explicit path name: User2
Example 43-10 Displays SPAN Mapping Information
switch# show span session
Session 2 (active)
Destination is fc-tunnel 100
No session filters configured
Ingress (rx) sources are
Egress (tx) sources are
Example 43-11 Displays the FC Tunnel Interface
switch# show interface fc-tunnel 200
fc-tunnel 200 is up
Dest
Source IP Addr: 200.200.200.4
Explicit Path Name:
Default SPAN and RSPAN Settings
Table 43-1
Table 43-1
Parameters
SPAN session
If filters are not specified
Encapsulation
SD port
Cisco MDS 9000 Family Configuration Guide
43-30
150
fc3/1
100
fc3/1
10.20.1.2 loose
10.20.1.3 strict
10.20.50.1 strict
10.20.50.4 loose
fc2/16,
fc2/16,
IP Addr: 200.200.200.7
lists the default settings for SPAN parameters.
Default SPAN Configuration Parameters
Tunnel ID: 200
LSP ID: 1
Default
Active.
SPAN traffic includes traffic through a specific interface from all active
VSANs.
Disabled.
Output frame format is Fibre Channel.
Chapter 43
Monitoring Network Traffic Using SPAN
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Advertisement
Table of Contents
