Recovery For Switches With Dual Supervisor Modules - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Corrupted Bootflash Recovery
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Exit to EXEC mode.
Step 4
switch(boot)(config-mgmt0)# end
Issue the init system check-filesystem command. As of Cisco MDS SAN-OS Release 2.1(1a), this
Step 5
command checks all the internal file systems and fixes any errors that are encountered.
switch(boot)# init system check-filesytem
Copy the system image from the required TFTP server.
Step 6
switch(boot)# copy tftp://172.16.10.100/system-image1 bootflash:system-image1
Copy the kickstart image from the required TFTP server.
Step 7
switch(boot)# copy tftp://172.16.10.100/kickstart-image1 bootflash:kickstart-image1
Step 8 Verify that the system and kickstart image files are copied to your bootflash: filesystem.
switch(boot)# dir bootflash:
12456448
12288
27602159
Usage for bootflash://sup-local
135404544 bytes used
49155072 bytes free
184559616 bytes total
Load the system image from the bootflash: filesystem.
Step 9
switch(boot)# load bootflash:system-image1
Uncompressing system image: bootflash:/system-image1
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
Would you like to enter the initial configuration mode? (yes/no): yes
See the
Note

Recovery for Switches with Dual Supervisor Modules

This section describes how to recover when one or both supervisor modules in a dual supervisor switch
have corrupted bootflash.
Cisco MDS 9000 Family Configuration Guide
6-36
Jul 30 23:05:28 1980
Jun 23 14:58:44 1980
Jul 30 23:05:16 1980
"Initial Setup Routine" section on page
If you enter no at this point, you will return to the
configure the switch.
kickstart-image1
lost+found/
system-image1
4-2.
login prompt, and you must manually
switch#
Chapter 6 Software Images
OL-6973-03, Cisco MDS SAN-OS Release 2.x