Configuring Luns In Ivr Zoning - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 18 Configuring Inter-VSAN Routing
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Command
Step 12
switch(config-ivr-zoneset)# member sample_vsan2-3
Step 13
switch(config-ivr-zoneset)# member sample_vsan4-5
Step 14
switch(config-ivr-zoneset)# exit
switch(config)
Step 15
switch(config)# ivr zoneset activate name IVR_ZoneSet1
switch(config)# ivr zoneset activate name IVR_ZoneSet1 force
switch(config)# no ivr zoneset activate name IVR_ZoneSet1
Step 16
switch(config-ivr-zoneset)# end
switch#

Configuring LUNs in IVR Zoning

LUN zoning can be used between members of active IVZs. Prior to Cisco MDS SAN-OS Release
2.1(1a), you can configure the service by creating and activating LUN zones between the desired IVZ
members in all relevant edge VSANs using the zoning interface. As of Cisco MDS SAN-OS Release
2.1(1a), IVR directly supports LUN zoning. For more details on the advantages of LUN zoning, see the
"About LUN Zoning" section on page
To configure LUNs in IVR zoning in Cisco MDS SAN-OS Release 2.1(1a) or later, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ivr zone name IvrLunZone
switch(config-ivr-zone)#
Step 3
switch(config-ivr-zone)# member pwwn
10:00:00:23:45:67:89:ab lun 0x64 vsan 10
switch(config-ivr-zone)# member pwwn
10:00:00:23:45:67:89:ab lun 0x64 vsan 10
autonomous-fabric-id 20
switch(config-ivr-zone)# no member pwwn
20:81:00:0c:85:90:3e:80 lun 0x32 vsan 13
autonomous-fabric-id 10
As of Cisco MDS SAN-OS Release 2.1(1a), you can configure LUN zoning in an IVZS setup.
Note
OL-6973-03, Cisco MDS SAN-OS Release 2.x
19-17.
Purpose
Enters configuration mode.
Configures an IVZ called IvrLunZone.
Configures an IVZ member based on the specified
pWWN and LUN value.
The CLI interprets the LUN identifier value
Note
as a hexadecimal value whether or not the
0x prefix is included.
Configures an IVZ member based on the specified
pWWN, LUN value, and AFID.
Removes an IVZ member.
Cisco MDS 9000 Family Configuration Guide
Configuring IVZs and IVZSs
Purpose
Adds the sample_vsan2-3 IVZ
as an IVZS member.
Adds the sample_vsan4-5 IVZ
as an IVZS member.
Returns to configuration mode.
Activates the newly created
IVZS.
Forcefully activates the
specified IVZS.
Deactivates the specified
IVZS.
Returns to EXEC mode.
18-23