Time Stamp Cleanup; Ficon Snmp Control - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Manually Enabling FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To configure host control, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ficon vsan 2
switch(config-ficon)#
Step 3
switch(config-ficon)# no host
set-timestamp
switch(config-ficon)# host set-timestamp

Time Stamp Cleanup

You can clear time stamps only from the Cisco MDS switch—not the mainframe.
Note
Use the clear ficon vsan vsan-id timestamp command in EXEC mode to clear the VSAN clock.
switch# clear ficon vsan 20 timestamp

FICON SNMP Control

By default, SNMP users can configure FICON parameters through the Cisco MDS 9000 Family Fabric
Manager.
If you disable SNMP use in the Cisco MDS switch, you cannot configure FICON parameters using the
Note
Fabric Manager.
To configure SNMP control, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ficon vsan 2
switch(config-ficon)#
Step 3
switch(config-ficon)# no snmp port
control
switch(config-ficon)# snmp port control
Cisco MDS 9000 Family Configuration Guide
24-18
Purpose
Enters configuration mode.
Enables FICON on VSAN 2.
Prohibits mainframe users from changing the
VSAN-specific clock.
Allows the host to set the clock on this switch
(default).
Purpose
Enters configuration mode.
Enables FICON on VSAN 2.
Prohibits SNMP users from configuring FICON
parameters.
Allows SNMP users to configure FICON parameters
(default).
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Chapter 24 Configuring FICON