Table of Contents
Advertisement
Chapter 10
Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Table 10-3
show module Command
Status Output
powered up
testing
initializing
failure
ok
power-denied
active
HA-standby
standby
Connecting to a Module
At any time, you can connect to any module using the attach module command. Once you are at the
module prompt, you can obtain further details about the module using module-specific commands in
EXEC mode.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Module States
Description
The hardware has electrical power. When the hardware is powered up, the
software begins booting.
The switching module has established connection with the supervisor
supervisor and the switching module is performing bootup diagnostics.
The diagnostics have completed successfully and the configuration is being
downloaded.
The switch detects a switching module failure upon initialization and
automatically attempts to power-cycle the module three times. After the third
attempt it continues to display a failed state.
The switch is ready to be configured.
The switch detects insufficient power for a switching module to power up
(see the
"Displaying Environment Information" section on page
This module is the active supervisor module and the switch is ready to be
configured.
The HA switchover mechanism is enabled on the standby supervisor module
(see the
"HA Switchover Characteristics" section on page
The warm switchover mechanism is enabled on the standby supervisor
module (see the
"HA Switchover Characteristics" section on page
Cisco MDS 9000 Family Configuration Guide
Connecting to a Module
9-11).
8-2).
8-2).
10-5
Advertisement
Table of Contents
