Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual page 203

Chapter 6 Software Images
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
You see the configured changes (see
Figure 6-6
Press the Esc key to return to the main menu.
Step 12
Choose Write to CMOS and Exit from the main screen to save your changes.
Step 13
Note
Caution
You see the following prompt:
switch(boot)#
Step 14 Issue the init system command at the
switch(boot)# init system
The
Note
OL-6973-03, Cisco MDS SAN-OS Release 2.x
BIOS Setup Configuration (CMOS) Changes
These changes are saved in the CMOS.
The switch must have IP connectivity to reboot using the newly configured values.
prompt indicates that you have a usable kickstart image.
switch(boot)#
The init system command also installs a new loader from the existing (running) kickstart image.
Figure 6-6).
prompt.
switch(boot)#
Cisco MDS 9000 Family Configuration Guide
Corrupted Bootflash Recovery
6-33