Displaying Dns Host Information; Default Settings - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Displaying DNS Host Information

Use the show hosts command to display the DNS configuration (see
Example 36-10 Displays Configured Host Details
switch# show hosts
Default domain is cisco.com
Domain list: ucsc.edu harvard.edu yale.edu stanford.edu
Name/address lookup uses domain service
Name servers are 15.1.0.1 15.2.0.0
Default Settings
Table 36-1
Table 36-1
Parameters
FSPF
SPF computation
SPF hold time
Backbone region
Acknowledgment interval (RxmtInterval)
Refresh time (LSRefreshTime)
Maximum age (MaxAge)
Hello interval
Dead interval
Distribution tree information
Routing table
Load balancing
In-order delivery
Drop latency
Static route cost
Remote destination switch
Multicast routing
Cisco MDS 9000 Family Configuration Guide
36-24
lists the default settings for FSPF features.
Default FSPF Settings
Example
Default
Enabled on all E ports and TE ports.
Dynamic.
0.
0.
5 seconds.
30 minutes.
60 minutes.
20 seconds.
80 seconds.
Derived from the principal switch (root node).
FSPF stores up to 16 equal cost paths to a given
destination.
Based on destination ID and source ID on different, equal
cost paths.
Disabled.
Disabled.
If the cost (metric) of the route is not specified, the
default is 10.
If the remote destination switch is not specified, the
default is direct.
Uses the principal switch to compute the multicast tree.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Chapter 36 Configuring IP Services
36-10).