One-Time Schedule Definition; Schedule Deletion - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Scheduler Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
The most significant fields in the time parameter are optional. If you omit the most significant fields, the
values are assumed to be the same as the current time. For example, if the current time is September 24th,
2004, 22:00 hours, then the commands are executed as follows:
•
•
•
•
If the time interval configured for any schedule is smaller than the time taken to execute its assigned
Note
job(s), then the subsequent schedule execution occurs only after the configured interval amount of time
has elapsed following the completion time of the last iteration of the schedule. For example, a schedule
is executed at 1-minute intervals and a job assigned to it takes 2 minutes to complete. If the first schedule
is at 22:00 hours, the job finishes at 22:02 following which, the 1-minute interval is observed and the
next execution occurs at 22:03 which finishes at 22:05.

One-Time Schedule Definition

When you specify a one-time job execution, that job is only executed once
To specify a one-time job for the command scheduler, follow these steps:
Command
Step 1
switch# conf t
switch(config)#
Step 2
switch(config)# scheduler schedule name configureVsan99
switch(config-schedule)#
Step 3
switch(config-schedule)# job name addMemVsan99
Step 4
switch(config-schedule)# time start 2004:12:14:23:00
switch(config-schedule)# no time

Schedule Deletion

To delete a schedule, follow these steps:
Command
Step 1
switch# conf t
switch(config)#
Step 2
switch(config)# no scheduler schedule name
weekendbackup
Cisco MDS 9000 Family Configuration Guide
15-6
The time start 23:00 repeat 4:00:00 command implies a start time of September 24th, 2004 23:00
hours.
The time daily 55 command implies every day at 22:55 hours.
The time weekly 23:00 command implies every Friday at 23:00 hours.
The time monthly 23:00 command implies the 24th of every month at 23:00 hours.
Chapter 15 Scheduling Maintenance Jobs
Purpose
Enters the configuration mode.
Defines a job schedule
(configureVsan99) and enters the
submode for that schedule.
Assigns a predefined job name
(addMemVsan99) for this schedule.
Specifies a one-time execution on
December 14th, 2004 at 11 p.m.
Deletes the time assigned for this
schedule.
Purpose
Enters the configuration mode.
Deletes the defined schedule.
OL-6973-03, Cisco MDS SAN-OS Release 2.x