Upgrade Status Verification - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Upgrade Status Verification

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Do you want to continue with the installation (y/n)?
Install is in progress, please wait.
Syncing image bootflash:/boot-2.1.2 to standby.
[####################] 100% -- SUCCESS
Syncing image bootflash:/isan-2.1.2 to standby.
[#
disk may be full).
Install has failed. Return code 0x40930013 (Syncing images to standby failed).
----------------------insufficient space message
Please identify the cause of the failure, and try 'install all' again.
Dec 15 19:36:42 switch %SYSMGR-3-SERVICE_TERMINATED: Service "installer" (PID 5470) has
finished with error code SYSMGR_EXITCODE_FAILURE_NOCALLHOME (20).
Example 6-7
Example 6-7
install all system bootflash:junk kickstart bootflash:junk
Verifying image bootflash:/junk
[#
type and boot variable).
Compatibility check failed. Return code 0x40930011 (Image verification failed).
Hacienda# Jan 19 00:20:35 Hacienda %SYSMGR-3-SERVICE_TERMINATED: Service "installer" (PID
5664) has finished with error code SYSMGR_EXITCODE_FAILURE_NOCALLHOME (20).
Upgrade Status Verification
Use the show install all status command to view the on-going install all command or the log of the last
installed install all command from a console, SSH, or Telnet session.
This command presents the install all output on both the active and standby supervisor module even if
you are not connected to the console terminal. It only displays the status of an install all command that
is issued from the CLI (not the GUI). See
Example 6-8
switch# show install all status
There is an on-going installation... <---------------------- in progress installation
Enter Ctrl-C to go back to the prompt.
Verifying image bootflash:/b-1.3.0.104
-- SUCCESS
Verifying image bootflash:/i-1.3.0.104
-- SUCCESS
Cisco MDS 9000 Family Configuration Guide
6-18
7 slc
7 bios v1.1.0(10/24/03)
8 slc
8 bios v1.1.0(10/24/03)
9 ips
9 bios v1.1.0(10/24/03)
] 0% -- FAIL. Return code 0x401E0008 (request was aborted, standby
displays the install all command output of a failed operation due to an invalid image.
Failed Operation Due to an Invalid Image
] 0% -- FAIL. Return code 0x4045001E (mismatch between actual image
Displays the install all Command Output
1.3(1) 2.1(2)
v1.0.8(08/07/03)
1.3(1) 2.1(2)
v1.0.8(08/07/03)
1.3(1) 2.1(2)
v1.0.8(08/07/03)
[n] y
Example 6-8.
Chapter 6 Software Images
yes
no
yes
no
yes
no
<----
OL-6973-03, Cisco MDS SAN-OS Release 2.x