Using The Stamp - Ricoh FAX4800L Operator's Manual

SENDING A FAX MESSAGE

Using the Stamp

Press the Stamp key to have faxes you send stamped. When the Stamp indicator
is lit, the machine stamps a small mark on the bottom of each page. During
memory transmission, the stamp indicates that the page was successfully stored.
For immediate transmission, it shows that the page was sent successfully. You
must switch the stamp on before you press Start , or the machine will not stamp
the first page.
If you wish the stamp to be at the top of each page instead of at the bottom,
contact your service representative.
Changing the Stamp Home Position Setting
If you wish to change the Stamp default setting, do the following.
(See page 227 if you need more information about the User Parameter settings
adjustment procedure).
1. Function 6 0 2 2 2 2 6 and 3.
At this time, you can print a User
Parameter List if you press
and Start.
The settings for switch 00 are now shown
on the bottom line of the display.
The setting that you need to change is
that for digit 0.
2. If you wish to change the setting, press 0
on the ten key pad.
3. Finish: Yes and Function.
36
ROUTINE OPERATION
USER PARAMETER
DEFAULT: 01000000
SWITCH00: 01000000
SWITCH00: 0000 0000
Digit 0 (Double Underlined)
0: Verification stamp off
1: Verification stamp on
PRINT LIST →
↑
YES TO END ↓