Using The Stamp - Ricoh MV310 Operator's Manual

Using the Stamp
FAXING
You have 60 seconds. If you do not place a page on the exposure glass and
press Start within the remaining time, the machine will start to dial.
Either:
Place the next page on the exposure glass and press Start. The page
will be scanned and stored.
or
If you have no more pages, press Yes. The machine will dial the first
destination (or, if you selected Send Later, it will return to standby mode
and the fax message will be sent at the time that you selected.)
Using the Stamp
Press the Stamp key to achieve the transmission verification stamp.When the
Stamp indicator is lit, the machine stamps a small mark on the bottom of each
page. During memory transmission, the stamp indicates that the page was
successfully stored. For immediate transmission, it shows that the page was
sent successfully. You must switch the stamp on before you press Start, or the
machine will not stamp the first page.
If you wish the stamp to be at the top of each page instead of at the bottom,
contact your service representative.
If you wish to change the Stamp default setting, set by user parameter switch
00, bit O.
0: Verification stamp off
1: Verification stamp on
25