Table of Contents
Advertisement
TRANSMISSION
Specified Image Area (Function Upgrade Card Required)
Overview
If you only wish to transmit a part of the page, use this feature. You tell the
machine what area to scan by specifying two parameters: The Skip Length, and
the Scan Length. See the following diagram.
This feature cannot be used when you are transmitting using an OMR sheet,
Immediate Transmission, or when you are making a copy.
Before you can to use the feature during a transmission, you must:
Set up the feature using Function 74 (see the next page).
Program one of the User Function Keys so that you can activate this feature
during the transmission procedure.
Note: If the skip length is longer than the paper, the machine stops scanning.
When you send with Specified Image Area, Parallel Memory Transmission
is cancelled and normal Memory Transmission takes place.
If Parallel Transmission is on, you cannot send just a few pages with
Specified Image Area. Should you want to send a few pages with Speci-
fied Image Area, turn Parallel Transmission off using function 63 (set
switch 07 digit 2 to "0").
Changing the Specified Image Area On/Off Home Position Setting
In a new machine, this setting is off. If you change this setting to "On", the image
area that you input (using Function 74 on the next page) will be used for all of
your transmitted pages, unless you switch off the light under the User Function
Key that you programmed for this feature.
1. Function 6 0 2 2 2 2 6 and 3.
86
Skip
Length
Scan
Length
ADVANCED FEATURES
USER PARAMETER
DEFAULT:
01000000
SWITCH00:
01000000
PRINT LIST →
↑
YES TO END ↓
Advertisement
Table of Contents
