Fuel Tank With Attachments, Removing And Installing - Audi Q7 2007 Repair Manual

– Install the new locking flange seal dry.
– Bring the left locking flange into the installation position.
• The tab -2- on left locking flange faces toward the arrow mark‐
ing and must lie between tabs -1 and 3- on fuel tank.
– Install locking flange cover.
– Insert the frame into the floor covering. Refer to the Parts Cat‐
alog and ⇒ Body Interior; Rep. Gr. 70 .
– Install the left seat cushion in the second row. Refer to ⇒ Body
Interior; Rep. Gr. 72 .
– Be sure to follow the procedure for connecting the battery and
afterwards. Refer to ⇒ Electrical Equipment; Rep. Gr. 27 .
1.3 Fuel Tank with Attachments, Removing
and Installing
Special tools and workshop equipment required
♦ Engine/Gearbox Jack - VAG1383A-
♦ Subframe Support - T10031-
Removing
Follow all safety precautions. Refer to
⇒ "1 Safety Precautions", page 1
Follow the guidelines for clean working conditions. Refer to
⇒ "2.1 Fuel Supply and Injection System, Clean Working Condi‐
tions", page 3 .
– On a vehicle with air suspension, activate vehicle lift mode.
Refer to ⇒ Suspension, Wheels, Steering; Rep. Gr. 43 .
– Open the fuel filler door.
Caution
Danger of causing damage to other electronic components
when disconnecting the battery.
♦ Complete the steps for disconnecting the battery.
– Disconnect the battery. Refer to ⇒ Electrical Equipment; Rep.
Gr. 27 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
WARNING
Risk of injury due to fuel tank weight.
♦ Fuel tank must be empty to remove.
– Empty fuel tank. Procedure. Refer to
⇒ "1.2 Fuel Tank, Draining", page 7
.
.
Audi Q7 2007 ➤
Fuel Supply System - Edition 10.2018
1. Fuel Tank with Attachments
11