PREVOST H3-41 Maintenance Manual page 535

SLEEVE ADJUSTMENT
12. Adjust sleeve to the values of FIGURE 10.
13. Once the proper length adjustment is done,
tighten the sleeve end ball joint clamp. To prevent
interference between the ball joint clamp bolts
with other components of the steering system, the
clamp bolt must be positioned horizontally as
shown on FIGURE 11. Tighten the clamp nut to
118-133 lbf-ft.
CAUTION
Do not re-use clamp
hardware.
Bolt and nut should be
replaced every time they
are unscrewed. While
assembling the clamp,
make sure the bolt does not touch the drag link
tube.
Writer:
FL
10/32"=8mm
FIGURE 9
FIGURE 10: NOTE
ORIENTATION OF THE CLAMP BOLT AT THE
SLEEVE END AND ON WHICH SIDE THE NUT
MUST BE POSITIONED
MI19-05A
Page 7 / 8
THE HORIZONTAL
<QF7720955 rev 7>