PREVOST H3-41 Maintenance Manual page 680

SECTION 18a: H3 SERIES BODY
1.70 Do not move the vehicle for 48 hours
Make sure room temperature is superior to 20°C (68°F) before gluing
Perform a visual inspection before installing side windows
2.00 * A) Clean using Anti-silicone
See SAV000001 section A.
B) Apply Sika 206 G+P
See SAV000001 section D.
2.05 Remove blue paper from drip molding.
Remove protective tape from double-
face self adhesive tape
2.10 Glue drip molding. Allow a gap of 1mm
minimum between top of drip molding
and panel.
2.15 Compress drip
compression
adherence.
2.20 Round off rear and front drip molding
corners.
76
PA1621 Maintenance Manual All Series
SECTION #2 DRIP MOLDING INSTALLATION
molding using the
roller to increase
|
Revised Sept 2019