Wheelchair Lift Cassette Compartment Door - PREVOST H3-41 Maintenance Manual

9.5.2

Wheelchair Lift Cassette Compartment Door

For the removal and installation of a wheelchair
lift (WCL) cassette compartment door body
panel, you will need:
A drill with drill bits;
Pneumatic hammer tool (Zip Gun);
Razor sharp window scraper or putty knife;
 Open damaged compartment door and
unfasten rub rail fixing bolts. Remove rub
rail.
 Unfasten bolts and disconnect cable if
necessary in order to remove door from
vehicle.
 Preferably install the door onto a work
surface where it can be solidly fixed.
Door Panel replacement
•
 Refer to SAV10054-67.
Compartment Door Adjustment
•
 Refer to baggage compartment door
procedure.
WCL Cassette Door Adjustment
•
The small door has a piano hinge on its lower
edge.
1. Install only two of the mounting screws,
at each end to adjust the door.
2. Close door and adjust in opening. A
1mm maximum difference between left
and right measured gap is accepted.
3. Door should close flush with the larger
door panel. Maximum flatness deviation
within 1mm.
4. Install the remaining screws and seal
with liquid Teflon #680098.
WCL Cassette Door latch adjustment
•
To allow adjustment of the latch mechanism,
lightly tighten
receptacle and striker support (arrows).
1. Place centering tool G34148_500 in the
receptacle cavity.
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
the retaining hardware on
69