PREVOST H3-41 Maintenance Manual page 965

HOW TO INSTALL A NEW "CLIP-ON" UNLOADER COIL
1. Loosen the screw securing the connector
to the coil and then unplug the connector
(A). Keep the screw and the connector
rubber gasket for later use.
2. Unscrew the aluminum cap and discard.
3. Remove the plastic capture nut and
discard.
4. Remove the coil and discard
5. Keep the O-ring on the stem.
6. Install the new clip-on coil on the stem.
7. Slide the coil over the stem assembly with
the O-ring at the base of the stem.
Writer:
EL
SUPPLEMENT
MI18-37
Page 13 / 14
<QF7720955 rev 7>