PREVOST H3-41 Maintenance Manual page 810

SECTION 18b: X3 SERIES BODY
FIGURE 121
FIGURE 122: LOCKING PLATE
Longitudinal adjustment
25. Check the gap between the door and the
adjacent panel at the level of the upper
attachment point of the arm on the door. The
gap should be ¼" (6 mm) (FIGURE 57).
Gap 1/4" (6 mm)
Tolerance is ± 3/64" (± 1mm)
126
PA1621 Maintenance Manual All Series | Revised Sept 2019
FIGURE 123
26. If the longitudinal position is out of tolerance,
adjust using the adjustment provided on the
inner side of the door, at the upper
attachment point of the arm on the door
(FIGURE 58).
FIGURE 124
27. Check the gap between the door and the
adjacent panel at the level of the lower
attachment point of the arm on the door. The
gap should be ¼" (6 mm) (FIGURE 59).
Gap 1/4" (6 mm)
Tolerance is ± 3/64" (± 1mm)
FIGURE 125
28. If the longitudinal position is out of tolerance,
adjust using the adjustment provided on the
lower attachment point of the arm on the
vehicle chassis (FIGURE 60).