PREVOST H3-41 Maintenance Manual page 708

SECTION 18b: X3 SERIES BODY
9.1.1 Front Bumper
The front bumper is hinged to give access to the
spare wheel and tire compartment. Pull the
handle located in the front service compartment
to open the spare wheel and tire compartment.
Bumper must first be tilted down before its
removal. Two people are required to remove and
install the front bumper. Safely support the
bumper and remove the two bolts on each
bumper side to separate the bumper from the
spare wheel compartment door. To install
bumper, reverse the removal procedure.
NOTE
On Commuter type vehicles, the front bumper
is hinged to give access to the steering gear
and to facilitate removal and installation. To
remove the bumper,
retaining bolts, located on each side next
to the headlights, and tilt down the bumper.
WARNING
Front bumper is heavy. Use proper lifting
equipment to support the bumper during the
removal and installation operations to avoid
personal injury.
FIGURE 12: FRONT BUMPER RELEASE HANDLE
24 PA1621 Maintenance Manual All Series | Revised Sept 2019
unscrew the top
18613
FIGURE 13: FRONT BUMPER AND SPARE TIRE
FIGURE 14: FRONT BUMPER REMOVAL
9.1.2 Headlights
Refer to Paragraph Headlights, included in
Section 06: Electrical of the Maintenance Manual
for complete information on headlights.
9.1.3 Rear View Mirrors (RAMCO)
Your vehicle is equipped with two exterior
mirrors.
The mirrors may be equipped with an optional
electric heating system which serves to minimize
ice and condensation on the mirror glass in
extreme weather conditions. Integral thermostats
are installed in both mirrors to avoid continuous
heating. Use the appropriate switch on the
dashboard to activate the defroster system on
both mirrors simultaneously. The mirrors can
easily be adjusted by using the remote controls
located on the L.H. side control panel. The
mirrors have easy to replace glass in case of
breakage. Remote control motors can also be
replaced.
18565