X3 Models Fog Light Removal And Replacement - PREVOST H3-41 Maintenance Manual

Install the new fog light pod on the pod
7.
support with the existing screws and
lockwashers.
Tighten screws to a torque value of
8.
26.5-35 lb-in (3-4 Nm)
.
FIGURE 100: FOG LIGHT INSTALLATION
9. Secure the wiring with a cable tie as shown
in Figure 100.
10. Reinstall the fog light subassembly on the
bumper support.
11. Plug the connector and secure all wiring.
12. Test the fog light.
16.9.2 X3 Models Fog Light Removal And
Replacement
1. Lower the bumper by pulling the release
handle located in the front electrical and
service compartment.
2. From the bumper inner side, dismount the
screws fixing the fog light subassembly from
the bumper.
FIGURE 101: FOG LIGHT MOUNTING BOLT
3. Dismount the screws (2) fixing the pod from
the fog light support, keep the screws and
the lockwashers.
FIGURE 102: FOG LIGHT POD DISMOUNT
Install the new fog light pod on the pod
4.
support with the existing screws and
lockwashers (Figure 102).
5. Tighten screws to a torque value of
6. 26.5-35 lb-in (3-4 Nm)
7.
8. Reinstall the fog light subassembly on the
bumper support.
9. Plug the connector and secure all wiring.
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 06: ELECTRICAL
91