PREVOST H3-41 Maintenance Manual page 811

FIGURE 126
Latch installation
1. Install strike plate C and pin E centered in
the available adjustment position provided by
respective slotted holes (FIGURE 127). The
components should be snug but not tight so
that they can move when the door will be
closed later on in this procedure.
FIGURE 127
2. Check that the two items identified with
arrows are snug but not tight (FIGURE 128).
FIGURE 128
3. Before adjusting the pin, make sure that it
doesn't exceed more than 2" (50mm) at the
first closing of the door (FIGURE 129).
Damage to the door can result if this
condition is not respected.
Not more than 2" (50mm)
FIGURE 129
4. Close the door gently.
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
127