Clearance, Identification And Marker Lights; Clearance And Identification Lights Removal And Replacement; Marker Lights Removal And Replacement; Docking And Cornering Lights - PREVOST H3-41 Maintenance Manual

16.7 CLEARANCE,
MARKER LIGHTS
The vehicle is equipped
identification and clearance lights (LED). The
clearance lights are mounted at each corner of
the coach near the top and the identification
lights are in the upper center of rear and front
sections.
16.7.1 Clearance and Identification Lights
Removal and Replacement
The rear clearance and identification lights are
red and the front ones are amber.
These lights are LED sealed units and should be
replaced as an assembly in accordance with the
following procedure:
1. Unscrew both "Phillips" screws, and then
remove the LED
connectors.
FIGURE 94: LED SEALED UNIT WIRE CONNECTION
2. Plug the new unit connectors. Engage the
mating parts; push until the connector is fully
seated. Turn slightly until you feel a click.
3. Position the new unit and maintain a
pressure on the unit to compress the rubber
seal. Tighten the "Phillips" screws.
IDENTIFICATION AND
with marker,
unit. Unplug the
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 06: ELECTRICAL
FIGURE 95: CLEARANCE/IDENTIFICATION LIGHTS
16.7.2 Marker
Replacement
The amber and red marker lights are mounted
along the sides of vehicle.
The side marker light is a sealed unit (LED) and
should be replaced
accordance with the following procedure:
1. Unscrew both "Phillips" screws, and then
remove the marker light unit. Unplug the
connector.
2. Plug the connector to the new marker light
unit. Position the new light assembly and
tighten the "Phillips" screws (19 lbs-in).
FIGURE 96: SIDE MARKER AND SIDE DIRECTIONAL
LIGHTS
16.8 DOCKING
LIGHTS
This vehicle is provided with two halogen
sealed-beam units that serve as cornering lights.
They are mounted on the vehicle as follows: one
is mounted on the front L.H. side service
compartment door, while the other is located
between the front wheel and the entrance door
on the R.H. side. The main function of these
lights is to increase lateral visibility when turning
a corner. These
simultaneously with the directional lights. On the
Lights Removal and
as an assembly
AND CORNERING
lights are energized
89
in