14. Perform the transversal adjustment by
moving the strike plate using the slotted holes
(FIGURE 135).
FIGURE 135
9. The latch bolt must engage not less than
13/32" (10mm) behind the strike plate.
13/32" (10mm) min
FIGURE 136
10. Screw in or out the two upper stoppers so
that the upper part of the door exceeds the
horizontal member by 5/32" to 3/16" (4mm to
5mm) (see FIGURE 137 & FIGURE 138).
11. Adjust the lower stopper in order to have the
lower part of the door even with the fender.
Tolerance is ± 3/64" (± 1mm)
FIGURE 137
FIGURE 138
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
129