Front Cap - PREVOST H3-41 Maintenance Manual

4. With the sharp edge blade, remove as much
of the remaining seal pieces as possible.
5. Sand with #120 or #150 sandpaper.
6. Wipe clean with alcohol
7. Prepare surface with SIKA #205 and let dry
for a minimum of 2 minutes.
8. Install a new seal using LOCTITE 414 glue.
9. Install the rear cap and fasten with pop
rivets.
CAUTION
Do not attempt this procedure unless you are
qualified and equipped to handle this job.

35. FRONT CAP

The front cap windshield frame does not need
any maintenance. It is held in place with bolts
and nuts. If it ever it has to be replaced, make an
appointment at a Prevost service center near
you.
PA1621 Maintenance Manual All Series
SECTION 18a: H3 SERIES BODY
|
Revised Sept 2019
71