Evaporator Compartment Door - PREVOST H3-41 Maintenance Manual

SECTION 18b: X3 SERIES BODY
9.5.5

Evaporator Compartment Door

FIGURE 80: EVAPORATOR DOOR (ALUMINUM)
For the adjustment of an evaporator door, you
will need:
 Centering tool G34148_500
• Door adjustment
1. Open the evaporator door.
2. Loosen the screws fixing the hinge to
hinge attachment or hinge to door
assembly. Loosening the screws allows
the evaporator door assembly to be
shifted "LEFT or RIGHT" and "UP or
DOWN" or "IN and OUT".
3. Adjust evaporator
position at the hinge.
4. Door exterior panel on hinge side should
be positioned
measured from bus frame out.
78
PA1621 Maintenance Manual All Series | Revised Sept 2019
door assembly
at 29mm +/- 2mm
5. Respect the required gap between
exterior finishing panels.
6. Tighten the hinge screws.
7. To allow adjustment
mechanism, lightly tighten the retaining
hardware on receptacle and receptacle
support to frame.
8. Place centering tool G34148_500 in the
receptacle cavity.
of the latch