PREVOST H3-41 Maintenance Manual page 627

FIGURE 9: ALUMINUM EXTRUSIONS - BUMPER SKIN
REMOVAL
9.1.3 Front Bumper
including spare
door.
1. Ask assistant to relieve spring tension with
assistant proper tool, and relieve spring
tension on one locking pin and remove it.
Slowly release spring tension and remove
the second locking pin. The spring is free.
Repeat procedure for the other spring.
FIGURE 10: FRONT BUMPER ASSEMBLY
NOTE
A special tool kit is available from Prevost: Kit
# 410671 including tool #410708.
2. Remove 4 cap screws holding bumper to
vehicle and remove bumper (Figure 10).
3. To install bumper, reverse the removal
procedure.
Assembly Removal
wheel compartment
PA1621 Maintenance Manual All Series
SECTION 18a: H3 SERIES BODY
9.2 FRONT BUMPER LICENSE PLATE
SUPPORT INSTALLATION
License plate supports are stored in the first
baggage compartment. Install supports as per
Figure 11.
FIGURE 11: LICENSE PLATE SUPPORTS
9.3 REAR BUMPER REMOVAL AND
INSTALLATION
WARNING
Rear bumper weighs approximately 180 lbs.
(80 kg). Use proper lifting equipment to support
the bumper during the removal and installation
operations to avoid personal injury.
1. Remove 6 nuts (3 on each side) holding
bumper assembly to vehicle and remove
bumper (Figure 12).
2. Let the bumper rest face down on the lifting
equipment platform.
3. To install bumper, reverse the procedure.
|
Revised Sept 2019
18500A
23