PREVOST H3-41 Maintenance Manual page 763

9. Close door to center the latch assembly.
10. Tighten the Receptacle screws only.
11. .Door exterior panel on latch side should
be positioned at 8mm +1mm from
frame. Make the adjustments by moving
the receptacle support.
12. Make sure that backing plate is parallel
to structure before tightening hardware
13. Make sure that skid bar only touches
slightly bus structure at bottom. The
door should not move up when closing.
14. Check that the door swings freely and
closes properly.
Door release in the event of a latch
•
failure.
If the door release mechanism is damaged or
ceases to function for any reason, the door can
be released by removing these screws on the
fore wall of the fender side
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
79