PREVOST H3-41 Maintenance Manual page 57

6. Unfasten and
compartment lighting fixture and turbocharger
fire suppression nozzle if applicable.
7. Disconnect
System control cable.
• Last
1. Inspect the power plant assembly to
ensure that nothing will interfere when
sliding out the
connections or hoses not mentioned in this
list as some vehicles are equipped with
special or aftermarket components.
2. Make sure the ten retaining bolts, washers
and nuts securing the power plant cradle
to the vehicle rear subframe are removed.
NOTE
Check if any spacer(s) have been installed
between power plant cradle and vehicle rear
subframe, and if so, note position of each
washer for reinstallation purposes.
3. Using a suitable
minimum capacity of 4,000 lbs (1 800 kg),
slightly raise the power plant cradle.
4. Pull engine out slowly from the engine
compartment. Make sure all lines, wiring
and accessories are disconnected and are
not tangled.
put aside engine
Exhaust Aftertreatment
cradle. Check for
equipment with
PA1621 Maintenance Manual All Series | Section 01 revised Feb 2019
a
SECTION 01 : ENGINE
21