PREVOST H3-41 Maintenance Manual page 498

SECTION 14: STEERING
FIGURE 8: POWER STEERING PUMP REMOVAL
8. Install the new power steering pump.
Torque-tighten bolts to specification.
NOTE
Use a new gasket.
9. Connect the hydraulic lines to the power
steering pump.
10. Install the fuel pump. Torque-tighten bolts to
specification.
NOTE
Use a new sealing ring. Check that the fuel
pump drive axle sits correctly in the power
steering pump.
11. Start the engine and let run for 5 minutes.
Make sure that there are no leaks.
12 PA1621 Maintenance Manual All Series | Section revised June 2019