Door Lateral Adjustment; Door Depth Adjustment - PREVOST H3-41 Maintenance Manual

FIGURE 64: PANTOGRAPH ARM ADJUSTMENT
3. Tighten the bolt.

26.2 DOOR LATERAL ADJUSTMENT

FIGURE 65: DOOR LATERAL ADJUSTMENT
1. Using a rubber mallet, adjust radiator door
positioning with reference to pantograph arm
so that the door is parallel to the lateral
panel and to the engine door.
2. Tighten the two bolts.
FIGURE 66: PROPER DOOR POSITIONING

26.3 DOOR DEPTH ADJUSTMENT

1. Close radiator door.
2. Check parallelism between radiator door and
rear fender (max. 0 ± 2 mm).
3. If the door is too far inside, adjust using a
rubber mallet (Refer to Figure 68).
4. Tighten the bolt.
5. Close the radiator door in order to verify that
latches adjustment is proper. If the gap is
too small or too big, adjust latch positioning.
FIGURE 67: DOOR DEPTH ADJUSTMENT
6. Make sure that latch striker pin engages
behind the strike plate at least 10 mm. Add
or remove spacers if needed. Check door fit
and operation. Tighten the latches bolts.
FIGURE 68: DEPTH ADJUSTMENT
PA1621 Maintenance Manual All Series
SECTION 18a: H3 SERIES BODY
|
Revised Sept 2019
65