Safety - PREVOST H3-41 Maintenance Manual

8.3.1

Safety

Care should be exercised in storing, handling,
mixing, and applying paint and chemicals listed
in this manual. The topcoat, primer, solvent,
catalysts, accelerators, and cleaners are highly
volatile and/or toxic if not properly used. Observe
all safety instructions marked on the different
packagings, as well as the following:
1. Do not smoke in the paint room or in adjacent
area exposed to residue fumes.
8.3.2 Surface Preparation and Paint Application
Surface Preparation
Cleaning
Priming
Basecoat
Clearcoat
If assistance or technical information on STANDOX products is needed, please dial: 1 (800) 551-9296
Aluminum and / or
Stainless Steel
Sand using P-150 grit sandpaper.
It is recommended to sandblast
rivets and panel edges
OLIMAG 35-70 blast media.
STANDOX silicone remover ST-11654 (68-2989)
STANDOX Reactive Etch Primer
ST-13908
* Wait 30 minutes then apply
STANDOX Non-Stop Füllprimer
ST-11000 (68-2973)
Refer to paint scheme or coach record for proper color code
and paint brand.
We recommend using the same paint brand to ease color
matching.
STANDOX 2K MS Rapid Clear ST-11760 (68-2979)
Allow 16 hours for drying
PA1621 Maintenance Manual All Series
SECTION 18a: H3 SERIES BODY
2. Wear respirators approved by the governing
safety and health regulations.
3. Maintain adequate ventilation at all times.
4. Dispose of any leftover paint mix properly.
5. Wear rubber gloves, rubber apron, and face
shield during all phases of paint and chemical
handling.
Fiberglass
Sand using P-180 or
P-240 sandpaper.
with
STANDOX Non-Stop
Füllprimer ST-11000
(68-2973)
Comments
Do not use paint remover
over aluminum or fiberglass.
Refer to product Technical
Data sheet for proper mixing
Refer to product Technical
Data sheet for proper mixing
Refer to product Technical
Data sheet for proper mixing
| 21
Revised Sept 2019