Evaporator Compartment Door (Aluminum) - PREVOST H3-41 Maintenance Manual

SECTION 18b: X3 SERIES BODY

10.5.4 Evaporator Compartment Door (Aluminum)

FIGURE 143: EVAPORATOR DOOR (ALUMINUM)
For the adjustment of an evaporator door, you
will need:
 Centering tool G34148_500
Door Adjustment
•
1. Open the evaporator door.
2. Loosen the screws fixing the hinge to hinge
attachment or hinge to door assembly.
Loosening the screws allows the evaporator
door assembly to be shifted "LEFT or
RIGHT" and "UP or DOWN" or "IN and
OUT".
3. Adjust evaporator door assembly position at
the hinge.
4. Door exterior panel on hinge side should be
positioned at 29mm +/- 2mm measured from
bus frame out.
138
PA1621 Maintenance Manual All Series | Revised Sept 2019
5. Respect the required gap between exterior
finishing panels.
6. Tighten the hinge screws.
7. To allow adjustment of the latch mechanism,
lightly tighten the retaining hardware on
receptacle and receptacle support to frame.
8. Place centering tool G34148_500 in the
receptacle cavity.