9.10.1 Front Steps Replacement Procedure
MATERIAL
Part No
682989
683097
685101
683916
1. Cut and remove damaged step(s).
2. Remove dirt and adhesive residue.
NOTE
In wintertime, condensation and cold temperature may greatly influence bonding parameters. Working
area must be at a temperature sufficient to prevent reaching condensation point. Mechanically preheat
working area (heat lamp or heat gun) or wait until vehicle reaches room temperature.
FIGURE 93: APPLICATION OF SIKA 221 GRAY
Anti-silicone
Sika 205 (1 liter)
Sika Remover 208
Sika 215 (1 liter)
Description
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
18641
Qty
A/R
A/R
A/R
A/R
97