PREVOST H3-41 Maintenance Manual page 741

9.3.3 Rear Bumper
Remove three bolts on each side holding
bumper to vehicle and remove bumper.
To install bumper, reverse the procedure.
FIGURE 47: REAR BUMPER
9.3.4 Exhaust Aftertreatment System
Access Door
1. Open exhaust aftertreatment system access
door.
2. Loosen the screws holding the panel to
hinge assembly.
3. Adjust the door position according to
distance required between exterior finishing
parts.
4. Tighten the nuts.
5. Check that the door swings freely and closes
properly.
18634
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
57